Alfaa uv intensity monitor manual

and quartz sleeve. All EcoStream UV systems use only a single UV lamp. The lamps used in the Alfaa EcoStream Models ECS60R – ECSR are of a special high intensity, high output germicidal type. The chamber is designed to mount both horizontally or vertically and should be secured to a suitable support. Control Panel. Alfaa UV - The Water And Air Purification Expert. Alfaa UV, (Ace Hygiene Products Pvt. Ltd.) is an ISO certified company. With close to two decades of experience, Alfaa UV is the undisputed leader and exporter of UV purification systems for Water (ranging from LPH to 2,30, LPH) and Air (UV for coil cleaning and In-duct purification). UV INTENSITY MONITOR. EcoStream UV systems are available with the option of a UV Intensity monitoring system which is essential when treating water having unknown physical and chemical properties or in cases where online validation of the system is a must. Tech Specification of Alfaa UV Manual For UV ECS R. Recommended Products. No.

3. A seven segment LED display monitors the remaining number of useful hours of the UV lamp (Time Elapse Meter) and the days the UV system has been in operation. 4. An audio-visual "Lamp Life Over" and "Lamp Failure" indicator. 5. The Ecostream+ models include a built in UV Intensity meter along with sensor. Agilent Infinity VWD User Manual 11 Introduction to the Variable Wavelength Detector 1 Optical System Overview Optical System Overview The optical system of the detector is shown in the figure below. Its radiation source is a deuterium-arc discharge lamp for the ultraviolet (UV) wavelength range from to nm. The light beam from the. DIN Rail UV Intensity MonitorTM The DIN Rail UV Intensity MonitorTM is designed to monitor a single UV source. This product receives an intensity signal from the Compact SensorTM and outputs a V proportional to the UV intensity. This allows the DIN Rail UV Intensity MonitorTM to be integrated into control systems.

Signalling “Low UV Intensity” The contact leaves rest position when the UV intensity is lower than the pre-alert threshold value but higher than the alarm threshold value*. Signalling “System Failure” The contact is in rest position when the UV intensity is lower than the alarm threshold value* (or when a UV lamp fails). 3. A seven segment LED display monitors the remaining number of useful hours of the UV lamp (Time Elapse Meter) and the days the UV system has been in operation. 4. An audio-visual “Lamp Life Over” and “Lamp Failure” indicator. 5. The Ecostream+ models include a built in UV Intensity meter along with sensor. Simple to install in space restricted areas, Alfaa HiFlo systems consume less space, cost less to operate, and perform more efficiently than any other comparable UV product. Extremely Precise UV Intensity Monitor Our new and innovative, fully calibrated UV sensor is encapsulated in a robust stainless steel housing that locks the sensor in place.