Ademco 5881 h manual

˚H CN-H˚(Canada) H ˚˚˚H EH* ˚˚˚˚˚ Ñ * The EH is an enhanced version of H, employing AdemcoÕs new SignalSentry“ technology to provide high security wireless transmissions for use in commercial fire installations. INTRODUCTION The /CN and / family of RF receivers are. ADEMCO apologizes for any misunderstanding that has arisen due to our recent ADEMCO installation instructions and user manuals. Note: Place the receiver and the TM transmitter module in a high, centrally located area for best reception. The TM. ADEMCO EH Manuals User Guides. User Manuals, Guides and Specifications for your ADEMCO EH Receiver. Database contains 1 ADEMCO EH Manuals (available for free online viewing or downloading in PDF): Installation instructions manual.

1. Remove th e receiver's cover by inserting and twisting a. screw driv er b lad e in t he s lot at the cent er of th e cov er' s low er. edge. 2. If the recei ver is to be m ounted w ithin t he contro l's. cabinet (refer to Figure 1): a. Remove the receiver's circuit board from its base by bending. AFAIK: the V20 can only have one receiver, the is the basically the same as the but made for Canadian market, changing receivers is only a matter of replacing the unit and rewiring [should be just four wires red, black, green and yellow]- might need to address it, the white box is just the enclosure - it is often cleaner to remove it and install it in the can. ENL, ENM, ENH. Receiver / commercial fire wireless receiver. Receiver - connects to four wire keypad data lines. ENL. Up to 8 zones. ENM. Up to 16 zones. ENH. UP to 64 zones depending on control panel.

h. Do the same with the other ground lug and antenna block. i. Insert the receiver’s two antennas through the two openings in the top of the cabinet, one into each block’s right-hand terminal, and tighten the screws to secure them. j. Affix the receiver's Summary of Connections label to the inside of the control's cabinet door. www.doorway.ru ADEMCO EN Series RF Receiver – Installation Instructions INTRODUCTION The EN RF Receiver is designed for use with control panels that support an RF receiver connection via the keypad terminals. • The EN Series Receivers recognize alarm, status, and keypad control messages from wireless transmitters operating at MHz. 1. Remove th e receiver's cover by inserting and twisting a. screw driv er b lad e in t he s lot at the cent er of th e cov er' s low er. edge. 2. If the recei ver is to be m ounted w ithin t he contro l's. cabinet (refer to Figure 1): a. Remove the receiver's circuit board from its base by bending.